Perfectpro USBBOX 2 Manual download pdf (Page 14)

Operating the radio – Aux In

1. Connect a stereo or mono audio source (like CD walkman or MP3

player) to the Aux In socket, which is located on the side, behind the

rubber cover.

2. Press the SOURCE button to select AUX input. Display will show AUX IN.

3. Play the le in the CD walkman or MP3 player.

4. Adjust the volume control to the required level.

Make sure rubber cover is closed well after use to prevent moist and dirt

from entering the radio.

LCD illumination

When radio is switched on, press any button except Power button will

illuminate the LCD display for approx. 15 seconds. However if you use

AC cord to power the radio, the LCD display will be always illuminated

until you turn the radio off by pressing Power button.

Using SD card and USB memory device

This section describes how to use your radio to access and playback

your audio files via USB memory devices and Secure Digital (SD,

SDHC) cards.

Important:

Your radio is only designed to work with USB memory devices. It is not in-

tended to be connected to hard disk drives or any other types of USB device.

The USBBOX2 has been tested with a range of USB memory devices of up

to 32 GB capacity and SD cards up to 2GB and SDHC cards up to 16 GB

are supported. However, there are different cards variants available not all

cards can be guaranteed to work in the USBBOX2. Memory must use the

FAT 16 or FAT 32 ling system in order to operate with the USBBOX2.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Perfectpro USBBOX 2 Manual Page 14